Tile Grout is a white cement based, polymer modified grout that gives hard dense joints which are resistant to shrinkage and cracking. Tile Grout can be used to fill the tile joints on walls and floors with a minimum width of 1mm to a maximum width of 12mm for both interior and exterior application.
Ready to use.
Wide joint bridging.
Can be used both indoor and outdoor tile grouting.
Excellent workability, smooth and easy to spread and easy clean-up.
No shrinking and no cracking.
It is durable and helps to achieve a more elegant, waterproof and flexible grout finish.
It can be used for ceramic, vitrified, mosaic, porcelain, quarry tiles, Bricks, Pavers, Slate and stones.
Method of Application:
Make sure that tile adhesive is fully set before beginning with grouting.
The surface should be clean, dry and free from dust or any other particles.
In a bucket add BrickLite Tile Grout and water in 1:3 proportions to make up the volume.
Mix thoroughly for 5 – 10 minutes to arrive at a good consistent paste.
Mixing can be done using a stirrer or manually.
Leave the paste for 10 minutes for settling.
The prepared paste should be used within 2 hours of preparation.
Then fill in the tile joints using the Tile Grout completely.
Remove excess grout from the surface by drawing diagonally across the joints
Store the bags in a dry place and avoid contact with wet area.
Persons found allergic to material should take proper care and better to use mask.
In case of contact with eyes or face, wash with plenty of clean water.